Quick Tech Hobby Over 75,000 Radio Control Products

TTR4570R  Super Decathlon 40 ARF - Red 64 inch

TTR4570Y  Super Decathlon 40 ARF - Yellow 64 inch

A favorite on the air show circuit, the Super Decathlon has thrilled spectators for decades. Now you can experience the same thrills by owning your own miniature replica!

Specification:
 Wing Span: 64"
 Wing Area: 694 sq in.
 Length: 45"
 Weight: 6 lbs.
 Req. Engine: .40 -.46 - 2-Cycle
 Req. Radio: 4 Channel

The Thunder Tiger ARF .40 sized Decathlon is a convenient size and an attention grabbing starburst color scheme makes this baby really stand out at the flying field. Now you can have a stand-off scale beauty with a fraction of the work.

It re-creates the classic lines and aerobatic potential of its full-size namesake. Every model is factory built from top grade balsa, ply and spruce. Covered in a colorful Oracover® / Ultracote® and furnished with factory painted fiberglass cowl and wheel pants. The unique aluminum wing struts are extruded in airfoil profile. All these features and flight characteristic will make you stand out on the flying line.
Features:

  • Built of precisely laser-cut balsa and lite ply

  • Furnished factory painted fiberglass cowl and wheel pants

  • Covered in bright, tough and repairable Oracover® / Ultracote®

  • Removable main wing design for easy transportation

  • Equips. scale-like aluminum wing struts

  • Available in two color schemes; yellow/blue & red/white

Requires:

  • Radio Set - Transmitter (4 channels), Standard Servos - x5, Receiver, Battery, Foam, Rubber Band.

  • Engine - Airplane engine (.40 to .46 - 2 Cycle), (.60 to .90 - 4 Cycle), Glow Plug, Glow Fuel (10 -15%), 1.5V Glow Starter, 12V Fuel Pump, 12V Battery, 12V Electric Starter, Glow Plug Wrench.

  • Adhesives - Instant setting Cyanoacrylate adhesive (thin CA), Slow setting Cyanoacrylate adhesive (thick CA),
    10 minute Epoxy (fast), 20 - 30 minute Epoxy (slow).

  • Tools - Ruler, Hobby knife and blades, Scissors, Steel straight edge, Long nose pliers and diagonal cutting pliers,
    Fine-point or felt-tip pen, Phillips and flat head screw drivers, Drill bits (1/16", 5/64", 3.4mm).