Quick Tech Hobby Over 75,000 Radio Control Products

TTR4572  Expo 3D ARF 53 inch

Are you serious about flying? Then look no further, we have the perfect 3D plane for you. Designed specifically for the 3D pilot. Only limited by the control inputs from the pilot.
Specification:
 Wing Span: 53 "
 Wing area: 725 sq. in.
 Length: 57 "
 Weight: 4.5 - 5 lbs.
 Engine: .40 - .46 2-Cycle
 Radio: 4 Channel
Are you flying better yet, well you will once you get you're Expo to your local field. Everyone will think your a seasoned 3D pilot as soon as it goes airborne. Outrageous maneuvers will seem effortless, constant positive control while doing 3D has never been better.

This plane is designed for 3D aerobatics and available in ARF version that only takes you a few hours in assembly. Built from precisely laser cut balsa and ply, covered in durable and easily repairable Oracover/UltracoteŽ. Large control surfaces that are counter balanced make 3D a breeze. The 3D Expo will do Blenders, Waterfalls, Harriers, Elevators, Snap rolls, and more...
Features:

  • State-of-the-art engineering that provide quick and easy assembly

  • Pre-built one piece wing with attractive trim scheme design and covered in Oracover/UltraCoteŽ

  • Custom-built and covered by skilled craftsmen, built from top quality
    balsa and plywood

  • Lightweight construction, gives optimal power-to-weight ratio

  • Large surface area on all control surfaces: aileron, elevator and rudder provide quick precise response

  • Designed for the extreme 3D maneuvers such as Harrier, Waterfall, Blender, Torque roll, just to name a few

Requires:

  • Radio Set -4 Channel radio, x5 standard servos, Receiver and battery pack, x1 "Y" style extension wire
    or x2 10" ext. wire, x2 20" ext. wires.

  • Engine - Airplane engine 2 Cycle (.40 - .46), Glow Plug, Glow Fuel (10% - 15%), 1.5V Glow Starter,
    12V Fuel Pump, 12V Battery, 12V Electric Starter, Glow Plug Wrench.

  • Adhesives - 5 minute Epoxy, 20-30 minute Epoxy, Instant setting Cyanoacrylate adhesive (thin CA) or
    Instant setting Cyanoacrylate adhesive (medium CA)

  • Tools - Hobby knife and blades, Fine-point or felt-tip pen, Phillips and flat head screw drivers, Long nose pliers,
    Diagonal cutting pliers, Mixing sticks for Epoxy, Drill bits (1/16, 5/64, 1/8), Paper Towels, Scissors,
    1/2 masking tape, Straight building board, Reamer, File.