| MCD101 |
STD
REACH NI-STARTER W/CHG
The NI-STARTER? is the original glow plug igniter designed
for easy, reliable starting of glo fuel model engines. It locks onto
the glow plug. Just push down, rotate, and it's locked onto the glow
plug for hands free operation. It has a high capacity ni-cad power
source and usually provides over fifty starts off one full charge,
based on 15 to 20 second normal starts. All versions of the
NI-STARTER? carry a 180 day warranty against defects in workmanship or
the materials used. We further have an original ownership policy for
the NI-STARTER? beyond the warranty, contact us directly for the
details. |
$28.95 |
| MCD104 |
EXT
REACH NI-STARTER W/CHG |
$29.95 |
| MCD105 |
STD
REACH NI-STARTER |
$17.95 |
| MCD108 |
EXTENDED
RCH NI-STARTER |
$18.95 |
| MCD121 |
TORK
STARTER W/CHG
Tork
Starter. . .
Self-contained glow plug igniter battery, as well as a glow-plug wrench.
It is designed to release compression on engines, while applying power. It
does not lock-on, but pushes on and pulls off the plug connection. One
full charge provides 50 consecutive starts. Recharges hundreds of times. |
$28.95 |
| MCD122 |
TORK
STARTER W/O CHG
|
$17.95 |
| MCD130 |
FIELD
TRICKLE CHG
 The
12V Field Trickle Charger is small, light weight, and attaches to any
convenient place on your field box. It is powered by the flight box
12V battery. The Trickle charger has a Red L.E.D. to show when it is
charging. It charges at 1.5V 100ma. This unit is designed to put a
slow constant charge into your NI-STARTER? or TORK-STARTER? while at
the flying field to keep your battery charged up. Do not use the
Trickle Charger as your main source for re-charging your units.
(NI-STARTER? not Included).
|
$17.95 |
| MCD170 |
ON-BOARD
IGNITION SYSTEM
Use your Ni-Starter to supply power to your glow plug while flying.
Everything stays in place in flight, yet it’s easy to remove to
recharge.
|
$16.95 |
| MCD201 |
METERED
NI-STARTER W/CHG
The Metered NI-STARTER? has a durable, shock
resistant, dual faced amp meter to show the condition of your glow plug.
When attached to your glow plug the meter will indicate plug condition,
good or failed. This aids in determining the cause of many starting
problems. The meter does not indicate the NI-STARTER? charge condition.
All versions of the NI-STARTER? carry a 180 day warranty against defects
in workmanship or the materials used. We further have an original
ownership policy for the NI-STARTER? beyond the warranty, contact us
directly for the details.
|
$33.95 |
| MCD205 |
METERED
NI-STARTER W/O CHG |
$22.95 |
| MCD443 |
REM
GLOW PLUG ADAPTOR KIT
 PlugLock
adapter supplies power to your concealed glow plug from a remote
location. The 5/8" adapter is for most standard glow plug
applications. The Kit includes, the PlugLock (Glow Plug) adapter with a
12" red wire, 12" black ground wire, ground lugs, powerhead
with nut, mounting bracket, and heat shrink tubing. Kits are available
for Single or Twin Cylinder engines. There are two PlugLock (Glow Plug)
adapter lengths available, standard 5/8" and for deeply recessed
glow plugs, the 1" adapter. Adapter heads and replacement wires are
available separately if you should need them.
|
$10.95 |
| MCD474 |
4.8V Pulsed On Board Glow Driver - Four Cylinders
FOUR CYCLE ENGINE
 The
Driver is controlled by your TX at any time you desire, using an
available channel, or it can be paralleled with your throttle servo
using a "Y" cord for automatic operation at low throttle
settings (fully adjustable set point). This unit is set up for a Four
Cylinder Engine. Custom Modification: We can customize your
glow plug leads on your Mcd473 - Mcd479 at no-charge. You can
specify wire length up to 72" and we can install your Molex pins
for you. Just fill in specs on the order form under "Customer
Notes". Custom units must be ordered direct from us will take
extra time for assembly
|
$128.45 |
